Gefen EXT-HD-SL-444 User Manual page 55

Operating the 4x4 Seamless Matrix for HDMI
Use the ▲ or ▼ buttons to highlight the option to change. The IP Mode option will be
5.
highlighted, automatically.
6. Once the desired option is highlighted, press the Select button to select it. If using the
IR remote control, press the OK button.
When an option is selected, its current value will be highlighted in orange.
N E T W O R K
I P M O D E
T Y P E S E L E C T
B Y T E 1
B Y T E 2
B Y T E 3
B Y T E 4
R E - L I N K
T I M E O U T ( M i n . )
H T T P P O R T
R E S TO R E D E FA U LT
B A C K
E X I T
S TAT I C I P N O T L I N K E D
7. Use the ◄ or ► buttons to change the current value.
8. Press the Select button to accept the current changes. If using the IR remote control,
press the OK button.
Set this option to either Static or DHCP. If using the Static option, the IP address must be
specified. Use the Byte1, Byte2, Byte3, and Byte4 options to set each of the digits in the IP
address, subnet mask, and gateway.
Use this option to switch between the IP address (IP), subnet mask (Mask), and gateway
(Gate).
Use the Byte1, Byte2, Byte3, and Byte4 options to set each of the digits in the IP address,
subnet mask, and gateway.
Use this option to attempt to re-link to the network using the current IP settings.
S TAT I C
I P
1 9 2
1 6 8
1
7 2
1 0
8 0
O F F
IP Mode
Type Select
Byte
Re-link
page | 45
Menu System