Commands - Gefen EXT-HD-SL-444 User Manual

Advanced Operation

Commands

Command
#display_telnet_welcome
#fadefault
#help
#hdp_pulse
#lock_edid
#lock_matrix
#mask
#mute
#power
#reboot
#recall_preset
#save_preset
#set_bank_name
#set_brightness
#set_contrast
#set_edid
#set_gateway
#set_hdcp
#set_http_port
#set_hue
#set_input_name
#set_ipadd
#set_ipmode
#set_netmask
#set_output
#set_output_name
#set_preset_name
#set_saturation
#set_telnet_pass
#set_telnet_port
#set_udp_port
#set_udp_remote_ip
#set_udp_remote_port
#set_webui_ad_pass
#set_webui_op_pass
Description
Enables / disables the Telnet welcome message
Resets the current routing and masking state to
factory-default settings
Displays the list of available commands
Cycles with HPD line on the specified output
Locks the local EDID when the matrix is power-cycled
Locks / unlocks the matrix
Masks the specified outputs
Enables / disables muting on all outputs
Toggles the power on the matrix
Reboots the matrix
Loads the specified routing preset into memory
Saves a routing preset to memory
Assigns a name to the specified EDID bank
Sets the brightness level for all outputs
Sets the contrast level for all outputs
Assigns the specified EDID to an input or bank
Sets the gateway address
Enables / disables HDCP detection
Sets the HTTP listening port
Sets the hue for all outputs
Assigns a name to the specified input
Sets the IP address
Sets the IP mode (DHCP or static)
Sets the subnet mask
Sets the output resolution
Assigns a name to the specified output
Assigns a name to the specified preset
Set the saturation for the specified output
Sets the Telnet password
Sets the Telnet listening port
Sets the UDP serial port
Sets the remote UDP IP address
Sets the remote UDP port
Sets the Administrator password
Sets the Operator password
page | 56