Table 1-76 Interface Names; Table 1-77 Relationship Between The Physical Line That Sets The Group Band Control In The Same Nif And The Group Number That Can Be Set - Hitachi GR2000 Series Configuration Commands

Parameters
This parameter specifies the interface name for the interface that sets QoS queue
attributes. The following table displays various interface names along with the
circuits and protocols that the interfaces supports.

Table 1-76 Interface Names

Interface
<Line Name>
<DLCI Name>
<Timeslot Name>
<Peer Name>
<VLAN Name>
*1: Frame Relay circuits can be specified only by <DLCI Name>.
Default:
This parameter specifies the queue list name. (QoS queue attributes must be set
before this command is invoked.)
Default:
Range of value:
Group numbers are set.
Default:
Range of value:
Table 1-77 Relationship Between the Physical Line That Sets the Group Band Control
Physical line that sets the
group band control.
Line number zero
Line number other than zero
*1: If a group number greater than three is set, communication is possible only through line number
zero.
GR2K-GA-0014
Ver. 07-02
Circuits (Protocols)
OC-3c, OC-12c, OC-48c, serial (PPP), T3, E3, Ethernet, Gigabit Ethernet
DLCI (Frame Relay [*1])
BRI (PPP), PRI (PPP), J2 (PPP), T1 (PPP), E1 (PPP)
ISDN
VLAN [ROUTE-OS6B]
None; only the displayed value is supported.
None
Character strings must begin with an alphabetic character
and contain no more than 14 characters.
No default is allowed.
The value setting range varies depending on the number of
physical lines that set the group band control in the same NIF.
Table 1-77 shows the relationship between the physical line
that sets the group band control in the same NIF and the
group number that can be set.
in the Same NIF and the Group Number That Can Be Set
Number of Groups
Physical line that sets the group band control in
the same NIF
One line
1 - 16 (*1)
-- (*1)
Filtering/QoS Information
All lines
1 - 2
1 - 2
1-155