Hitachi GR2000 Series Configuration Commands page 423

Table 5-5
export: invalid {RIP|RIPng} metric value at
<Metric> not in range 1 to 16
export: invalid route-filter number value at
<Value> not in range 1 to 65535
export: invalid vpn number value at <Value>
not in range 1 to <Max_Value>
export: IPv6 Interface not found at '<Interface
name>'
export: IPv6 prefix cannot be linklocal in
configuration
export: IPv6 prefix cannot be multicast in
configuration
export: linklocal address should be followed
by % (IPv6 interface name)
export: low end of range <Mask1> shorter
than prefix mask <Mask2>
export: low end of range (<Value1> bits) is
greater than high end (<Value2> bits) is
greater
export: mask not contiguous
export: metric option of route-filter must not be
define for {bgp|bgp4+}
export: Non-masked bits not zero for
<Address> mask <Mask>
export: Non-masked bits not zero for
<Address> masklen <Masklen>
export: not IPv6 prefix
export: out of range
export: preference option of route-filter must
not be define for export filter
export: route-filter name "< Name>" cannot be
specified
export: route-filter name "<Name>" longer
than 15 characters
GR2K-GA-0014
Ver. 07-02
Routing Protocol Error Messages (continued)
In export definition, the RIP/RIPng metric is invalid. Specify a value
within the range of 1 to 16.
<Metric>: Specified metric value
The specified ID number is invalid. Specify within the range of 1 to
65535.
<Value>: Specified ID number
The specified vpn number is invalid. Specify within the range of 1 to
<Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
The interface of the specified interface name cannot be found.
Specify it by using the defined interface name.
<Interface name>: Specified interface name
The link local address is specified in the network address. Do not use
the link local address.
The multicast address is specified in the network address. Do not
use the multicast address.
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
In the between specification, mask range lower limit value is
overlapped with specified mask. Specify the value so the mask range
does not overlap with specified mask.
<Mask1>: Specified mask range of lower limit
<Mask2>: Specified mask
In the between specification, mask range lower limit value is greater
than upper limit. Reduce lower limit value to less than upper limit
value.
<Value1>: Lower limit of Mask range
<Value2>: Upper limit of Mask range
Bit 1 of specified mask does not continue. Use a mask where bit 1
continues.
The metric option for the route filter is defined against the BGP/
BGP4+ protocol. Do not specify the metric option.
At mask, 1 is set to non-masked bit of specified address. Set
non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
At masklen, 1 is set to non-masked bit of specified address. Set
non-masked bit 0.
Addresses other than an IPv6 prefix are specified. Specify the IPv6
prefix.
The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
The preference option for the route filter is defined in the export filter.
Do not specify the preference option.
The specified route filter contains invalid protocol information or
network information. Specify the valid route filter name.
<Name>: Route filter name
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
Configuration Error Messages
5-33