Table 1-97 Packet Type - Hitachi GR2000 Series Configuration Commands

6. Display of blank entry number:
Display of all blank entry numbers:
Display of first blank entry numbers:
Related Commands
qos
qos-queue-list
qos-interface
qos-discard-mode
qos-ip-list-group
qos-tos-map
qos-ip
Related Information
For the flow control, refer to the GR2000 Applications Guide.
Precautions
1. The packets shown in the table below are distributed to each queue by fixed
priority regardless of the flow control parameter set using this command.
Replacing TOS is performed as a setting.

Table 1-97 Packet Type

Packet type
The IP packet this device generated (rip etc.)
The ICMP packet this device generated
The IP packet this device relayed:
(1) Packet with an option (IP header)
(2) Fragmented packet
(3) Redirected packet
(4) ARP unresolved packet
ARP (ARP Request/ARP Response) packet this device generated 8
Layer 2 packet this device generated (WAN, ATM)
*: Output priority class refers to the queue number that loads the packet.
2. The QoS IP frame condition list used in the QoS frame condition group settings
cannot be deleted.
3. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
GR2K-GA-0014
Ver. 07-02
Filtering/QoS Information
Queuing
Output Priority*
Priority
8 4
4 1
4 4
4
8 4
1-193