Hitachi GR2000 Series Configuration Commands page 469

Table 5-9
Maximum number of QoS IP list group
configurations are already defined.
Maximum number of QoS IPX configurations
already defined on the RP.
Maximum number of QoS IPX configurations
already defined.
No such filter group name.
No such filter interface in/out flag.
No such filter list number.
No such insert index.
No such name <name>.
No such QoS discard mode NIF number.
No such QoS interface name.
No such QoS interface queue list name.
No such QoS IP list group entry number.
No such QoS IP list group name.
No such set index.
No such shaper configuration.
Payload length not specified.
peak_rate out of range
phb scheduling class not specified.
Policy routing IP address not specified.
Port destination high is less than port
destination low.
Port source high is less than port source low.
QoS discard mode NIF number not specified. NIF number in QoS discard mode has not been specified. Specify an
QoS interface name not specified.
QoS interface queue list name not specified.
QoS IP in/out flag not specified.
GR2K-GA-0014
Ver. 07-02
Filter and QoS Information (Other than Flow Information) Error Messages
Maximum number of QoS IP group configurations are already
defined. Decrease group configuration to 256 entries or fewer.
The maximum number of QoS IPX information per RP has already
been set. Specify QoS IPX information in 32 types or less per RP.
Maximum number of QoS IPX configurations are already defined.
Allowed configuration number of QoS IPX information are up to
5RPs.
Group name of the IP filter interface has not been specified. Specify
the group name of the specified filter group.
Inbound/Outbound flag has not set. Specify Inbound/Outbound flag.
Filter list specified with IP filter group entry has not been specified.
Specify an entry number in the specified filter list.
An entry cannot be inserted on specified entry number. Use entry
number not exceeding the number of set entries.
Specified configuration information name not found. Specify existing
definition information name.
A name of <name> configuration information.
There is no such QoS discard mode NIF number. Specify NIF
number of NIF other than the already set ATM.
No such interface specified for QoS interface. Specify interface name
of an interface except the already set ATM line.
There is no such QoS queue list name specified in QoS interface.
Specify the QoS queue list name for the QoS queue list.
There is no such QoS IP group entry number. Specify entry number
of an already specified IP list.
There is no such IP group specified in QoS IP. Specify group name
of already set IP group.
An entry cannot be set on specified entry number. Use entry number
not exceeding the set number of entries. To add entries, use the
number of set entries +1 for entry value.
There is no specified shaper configuration information. Confirm the
specified shaper configuration information.
IP user data length has not been specified. Specify an IP user data
length or delete specification of IP user data upper limit/lower limit.
The input value exceeds the prescribed range. Set the value in the
range of 500 - 980000 in maximum bandwidth if Kbit/s is specified
and in the range of 1M - 980M if Mbit/s is specified.
Band configuration value has not set. Specify band configuration
value when band configuration type is cs or af.
Next hop IP address has not been specified. Specify next hop IP
address or delete policy routing specification.
Destination port number (high) is less than destination port number
(low). Specify a destination port number (high) greater than the
destination port number (low).
Source port number (high) is less than source port number (low).
Specify a source port number (high) greater than the source port
number (low).
NIF number.
QoS interface name has not been specified. Specify the interface
name.
QoS interface queue list name has not been specified. Specify a
QoS queue list name.
QoS IP in/out flag is not specified. Specify Inbound/Outbound flag.
Configuration Error Messages
5-79