Hitachi GR2000 Series Configuration Commands page 263

Description:
Default:
Range of value:
Description:
Default:
Range of value:
Examples
1. Setting parameters:
PEPID and the IP address of a primary server are set using a cops control
function.
PEPID, the IP address of a primary server, the port number of a primary server,
the IP address of a backup server, the port number of a backup server, a server
password, and a COPS password are set using a cops control function.
GR2K-GA-0014
Ver. 07-02
marks ("). Alphanumeric characters and special characters
can be entered. However, a character string can be entered
without using double quotation marks (") when no special
character (e.g., space) is contained in an entry character
string.
However, notice that the characters below cannot be used.
"(double quotation mark), { (beginning of brace), } (end of
brace), ' (single quotation mark), ; (semicolon), $ (dollar), and '
(reverse single quotation mark). For more information, see
Table 1-102
This parameter specifies the average packet size.
1024 (bytes)
24 to 65535 (bytes)
This parameter specifies the number of retry times when the
connection to the policy server fails. If reconnection to the
policy server has failed as many times as the specified retry
number, the policy information set to this device from the
policy server is cleared.
3
0 to 10
Filtering/QoS Information
1-221