Hitachi GR2000 Series Configuration Commands page 270

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Default:
Description:
Default:
Description:
Default:
Description:
Default:
2-4
- IPX routing interface can be defined only to the interface that
is set IP interface (except rmEthernet, AUX, tunnel. Therefore,
IPX interface alone cannot be defined.
- Up to 160 per system and up to 32 per RP can be defined.
This value is the IPX network count. For example, when 4
types of frames are set in Ethernet, consider that 4 interfaces
are used. In WAN or ATM, only 1 interface is used.
- When the specified interface is ATM, WAN frame relay, or
ISDN, ipx-arp setting is required. (When this setting is omitted,
uni-cast communication is not available.)
- In case of WAN frame relay, set ipx_outgoing option by dlci
command to the DLCI under the target frame relay. If not, IPX
packet is not relayed.
- In case of broadcast type ISDN, stop the sending of cycle
RIP/SAP and define the necessary RIP/SAP information by
static.
None (cannot be omitted)
This parameter is the watchdog packet's spoofing response
function switch. You can configure up to 160 per system and
32 per RP. Select from the following options:
Carry out the spoofing response (cycle)
Unconditionally carry out the spoofing response
Do not carry out the spoofing response
Periodic
This parameter is the filter function switch when the
serialization packet is received.
(Do not discard the serialization packet.)
(Discard the serialization packet.)
-serialization_filtering
This parameter is the forwarding switch when the diagnostic
packet is received.
(Do not forward diagnostic packet.)
(Forward diagnostic packet.)
-
GR2K-GA-0014
Ver. 07-02