Hitachi GR2000 Series Configuration Commands page 217

Description:
Default:
Range of value:
Flow Control Parameters
Flow control parameter
This parameter sets whether the contents of the band control set in this list are a
minimum guarantee band or maximum limitation band and whether the flow is
an important packet or normal packet when important packet protection (priority
band assignment) is performed in each band.
When the flow detected in this list is an important packet in a maximum
limitation band
When the flow detected in this list is a normal packet in a maximum limitation
band
When the flow detected in this list is an important packet in a minimum
guarantee band
When the flow detected in this list is a normal packet in a minimum guarantee
band
Default
None (The band control and important packet protection described above are not
performed.)
This parameter conforms to the conditions below when it is used.
Put the flow control parameter (UPC) of an important packet and normal packet
into the same setting state when performing important packet protection.
The upc_penalty operation when this parameter is set is as shown in the table
below.
GR2K-GA-0014
Ver. 07-02
This parameter specifies an EXP field value. The number of
packets that coincide with the flow detection conditions is not
displayed.
None (EXP is not contained in flow detection conditions.)
0-7
Filtering/QoS Information
1-175