Vrrp Information; Table 5-13 Vrrp Information Error Messages - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5.13

VRRP Information

Table 5-13 VRRP Information Error Messages

Message
Critical interface with target address not
specified.
Target address not specified.
Failure detection times is greater than check
trial times.
Recovery detection times is greater than
check trial times.
Check status interval is not in range of 1 to
255.
Check trial times is not in range of 1 to 10.
Failure detection times is not in range of 1 to
10.
Failure detection interval is not in range of 1 to
255.
Recovery detection times is not in range of 1
to 10.
Recovery detection interval is not in range of 1
to 255.
5-92
Contents
Critical interface is not set.
Set critical interface in order to set target address.
Target address is not set.
Set target address.
Failure detection times exceed check trial times.
Set a value less than check trial times.
Recovery detection times exceed check trial times.
Set a value less than check trial times.
Check status interval exceeds the prescribed range.
Set the value in the range of 1 - 255.
Check trial times exceeds the prescribed range.
Set the value in the range of 1 - 10.
Failure detection times exceeds the prescribed range.
Set the value in the range of 1 - 10.
Failure detection interval exceeds the prescribed range.
Set the value in the range of 1 - 255.
Recovery detection times exceeds the prescribed range.
Set the value in the range of 1 - 10.
Recovery detection interval exceeds the prescribed range.
Set the value in the range of 1 - 255.
GR2K-GA-0014
Ver. 07-02