Hitachi GR2000 Series Configuration Commands page 408

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 5-4
Relations between destination ip address and
local address in router configuration are
inconsistent.
Relations between destination IP address and
IP address in IP address configuration.
Relations between external destination ip
address and line type are inconsistent.
Relations between external destination ip
address and obn type are inconsistent.
Relations between external source ip address
and obn type are inconsistent.
Relations between IP address and destination
IP address are inconsistent.
Relations between ip address and local
address in router configuration are
inconsistent.
Relations between IP address and target
address in VirtualRouter configuration are
inconsistent.
Relations between next hop address and
destination IP address in IP configuration.
Relations between obn type and line type are
inconsistent.
Relations between obn type and proxy arp are
inconsistent.
Relations between physical interface type and
backup interface in backup configuration are
inconsistent.
Relations between policy routing IP address
and destination IP address in IP configuration.
Relations between vpn in IP configuration and
backup interface.
Relay address not specified.
Relay group name not specified.
Relay group not specified.
Relay list not specified.
Relay list number not specified.
Subject IP address not specified.
Subnet mask not specified.
The interface is neither ethernet nor gigabit
ethernet.
The total of interfaces exceeded 256.
The total of policy list entry (default is
specified in same policy group) exceeded 1.
5-18
IP Information Error Messages (continued)
Relations between destination ip address and local address in router
configuration are inconsistent. For the IP address of the destination
server (for IP without VPN defined), set an address different from the
local address for router information.
Relations between destination IP address and IP address in IP
address configuration are inconsistent. Reconfirm the set address.
Relations between external destination ip address and line type are
inconsistent. The line that can set external destination IP address is
Ethernet only.
Relations between external destination ip address and obn type are
inconsistent. When specifies external destination IP address, set
OBN line type to subscriber.
Relations between external source ip address and obn type are
inconsistent. When specifies external own IP address, set OBN line
type to subscriber or dps.
Relations between Ipv6 address and destination Ipv6 address are
inconsistent. For IPv6 and destination IPv6, set a different address.
Relations between ip address and local address in router
configuration are inconsistent. For the IP address of the destination
server (for IP without VPN defined), set an address different from the
local address for router information.
The IP address and Virtual Router target address are inconsistent.
Reconfirm the address setting.
Relations between next hop address and destination IP address in IP
configuration are inconsistent. Reconfirm the set address.
Relations between obn type and line type are inconsistent.
The line that can specify subscriber is other than Gigabit Ethernet,
ATM, or frame relay. The line that can specify dps is Ethernet only.
Relations between obn type and proxy arp are inconsistent.
When specifies subscriber or dps, set ARP proxy response switch to
off.
Relations between physical interface type and backup interface in
backup configuration are inconsistent. Check interface type in
backup interface. The relationship between the interface type and
the interface at the backup server. Recheck the interface type of the
interface at the backup server.
Relations between policy routing IP address and destination IP
address in IP configuration are inconsistent. Reconfirm the set
address.
Relations between vpn in IP configuration and backup interface are
inconsistent. Reconfirm vpn in IP or the backup interface.
Relay address not specified. Set DHCP relay address.
Relay group_name not specified. Set relay group name.
Relay group not specified. Set DHCP relay group first.
Relay list not specified. Set DHCP relay list first.
Relay list number not specified. Set DHCP relay address entry
number.
IP address is not specified. Set IP address.
Subnet mask has not been specified. Specify a subnet mask.
The interface is neither ethernet nor gigabit ethernet. Specify
interface of Ethernet or Gigabit Ethernet.
The total of interfaces exceeded 256. Set 256 or less lines.
The total number of default-designated policy list entries inside a
policy group has exceeded "1." Set the number below 1.
GR2K-GA-0014
Ver. 07-02