Hitachi GR2000 Series Configuration Commands page 427

Table 5-5
import: Non-masked bits not zero for
<Address> masklen <Masklen>
import: not IPv6 prefix
import: out of range
import: proto option of route-filter must not be
define for import filter
import: route-filter name "<Name>" cannot be
specified
import: route-filter name "<Name>" longer
than 15 characters
import: route-filter not found at <Value>
import: Set-attribute "<Name>" cannot be
specified
import: Set-attribute not found at <Value>
import: syntax error
import: tag option of route-filter must not be
define for {import filter | bgp | bgp4+ | rip |
ripng}
import: tag option of route-filter must not be
define for {import filter | bgp | bgp4+ | rip |
ripng}
ip: invalid vpn number value at <Value> not in
range 1 to <Max_Value>
network-filter: duplicate entry at <Address>
mask <Mask> [exact | refine]
network-filter: duplicate entry at <Prefix>/
<Prefixlen> [exact | refine]
network-filter: duplicate network-filter at
<Value>
network-filter: each network must belong to
the same family: <Name>
network-filter: invalid high end of range value
at <Value> not in range 0 to {32|128}
GR2K-GA-0014
Ver. 07-02
Routing Protocol Error Messages (continued)
At masklen, 1 is set to non-masked bit of the specified address.
Set non-masked bit 0.
<Address>: Specified address
<Masklen>: Specified mask length
Addresses other than an IPv6 prefix are specified. Specify the IPv6
prefix.
The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
The proto option for the route filter is defined in the import filter.
Do not specify the proto option.
The specified route filter contains invalid protocol information or
network information. Specify the valid route filter name.
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
The specified ID is not defined
Specify a defined ID.
<Value>: Specified ID
Filter information inherent to IPv4 is defined in IPv6. Do not specify
the filter information inherent to IPv4.
<Name>: Specified identifier
The specified ID number cannot be found.
Specify the defined ID number
<Value>: Specified ID number
Syntax error
The tag option for the route filter is defined in the import filter or the
BGP/BGP4+/RIP/RIPng protocol. Do not specify the tag option.
The tag option for the route filter is defined in the import filter or the
BGP/BGP4+/RIP/RIPng. Do not specify the tag option.
VPN number is out of valid range. Specify value within the range of 1
to <Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
In the network-filter definition, an network range is duplicated.
Specify a unique network range
<Address>: Specified Address
<Mask>: Specified mask
The network range is defined in duplication in the network-filter
definition. Specify the range so that the network range will not be
duplicated.
<Prefix>: Specified prefix
<Prefixlen> Specified prefix length
The specified ID has been already registered. Specify the other ID.
<Value>: Specified ID
A network information of different address family is mixed in the
network-filter. Specify the information so does not overlap with
deferent address in one network-filter name.
<Value>: Network filter name
In the between specification, upper limit value of mask range is
invalid. Specify a value within the range of 0 to 32/128.
<Value>: Upper limit of specified mask range
Configuration Error Messages
5-37