D-Link xStackTM DGS-3300 User Manual page 24

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
enable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
Success.
DGS-3324SRi:4#
Used to enable communication with and management of the
Switch using the Telnet protocol.
enable telnet <tcp_port_number 1-65535>
This command is used to enable the Telnet protocol on the
Switch. The user can specify the TCP or UDP port number the
Switch will use to listen for Telnet requests.
<tcp_port_number 1-65535>
ports are numbered between 1 and 65535. The "well-known"
TCP port for the Telnet protocol is 23.
Only administrator-level users can issue this command.
DGS-3324SRi:4#enable telnet 23
Command: enable telnet 23
Success.
DGS-3324SRi:4#
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the
Switch.
None.
Only administrator-level users can issue this command.
−
The TCP port number. TCP
21