D-Link xStackTM DGS-3300 User Manual page 178

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
enable admin
Parameters
Restrictions
Example usage:
To enable administrator privileges on the Switch:
DGS-3324SRi:4#enable admin
Password: ******
DGS-3324SRi:4#
config admin local_enable
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the password for the "local_enable" authentication method.
DGS-3324SRi:4#config admin local_enable
Command: config admin local_enable
Enter the old password: ******
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-3324SRi:4#
None.
Only administrator-level users can issue this command.
Used to configure the local enable password for administrator level
privileges.
config admin local_enable
This command will configure the locally enabled password for the
enable admin command. When a user chooses the "local_enable"
method to promote user level privileges to administrator privileges,
he or she will be prompted to enter the password configured here,
that is set locally on the Switch.
<password 15> - After entering this command, the user will be
prompted to enter the old password, then a new password in an
alphanumeric string of no more than 15 characters, and finally
prompted to enter the new password again to confirm. See the
example below.
Only administrator-level users can issue this command.
175