D-Link xStackTM DGS-3300 User Manual page 57

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
To download a PROM code file:
DGS-3324SRi:4#download prom_fromTFTP 10.48.74.121 c:\pXprom_2.01-B01d1.had
DGS-3324SRi:4# download prom_fromTFTP 10.48.74.121 c:\pXprom_2.01-B01d1.had
Warning!
Do not power off device before PROM upgrade process has completed!
Powering off the device during PROM upgrade may cause boot up device failure.
Upon upgrade completion, the device will reboot.
Are you sure you want to proceed with the PROM upgrade? (y/n) y
Connecting to server...........................Done.
Download prom code......................... Done.
Do not power off!
Please wait, programming flash..........Done.
Saving current settings to NV-RAM.....Done.
Please wait, the switch is rebooting...
upload
Purpose
Syntax
Description
Parameters
Used to upload the current switch settings or the switch history log
to a TFTP server or a CompactFlash memory card.
upload [cfg_toTFTP <ipaddr> <path_filename 64> |
log_toTFTP <ipaddr> <path_filename 64> | [firmware_toCF
<path_filename 64> image_id <int 1-2> | cfg_toCF
<path_filename 64> | log_toCF <path_filename 64>]
This command is used to upload either the Switch's current
settings, the Switch's history log or firmware to a TFTP server or a
CompactFlash memory card.
cfg_toTFTP − Specifies that the Switch's current settings will be
uploaded to the TFTP server.
log_toTFTP − Specifies that the Switch's current log will be
uploaded to the TFTP server.
firmware_toCF - Specifies that the Switch's current firmware will
be uploaded to the CompactFlash card.
cfg_toCF - Specifies that the Switch's current configuration
settings will be uploaded to the CompactFlash card.
log_toCF − Specifies that the Switch's current log will be uploaded
to the CompactFlash card.
<ipaddr> − The IP address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be
replaced by the uploaded file from the Switch.
image_id <int 1-2>- This Switch holds two places for
storing firmware so the user may store an extra firmware file
on the Switch. image_id 1 will hold the current firmware in
use on the Switch. The user may specify which firmware
version is to be uploaded to the CompactFlash card by
specifying the image_id of the firmware located on the
Switch. This parameter is only used for the firmware_toCF
parameter.
54