Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4# config syslog host 1 udp_port 6000
Command: config syslog host 1 udp_port 6000
Success.
DGS-3324SRi:4# config syslog host 1 ipaddress 10.44.67.8
Command: config syslog host 1 ipaddress 10.44.67.8
Success.
DGS-3324SRi:4# config syslog host 1 state enable
Command: config syslog host 1 state enable
Success.
DGS-3324SRi:4#
config syslog host all
Purpose
Used to configure the syslog protocol to send system log data to a
remote host.
Syntax
config syslog host all [severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | state [enable | disable]]
Description
The config syslog host all command is used to configure the
syslog protocol to send system log information to a remote host.
Parameters
all − Specifies that the command will be applied to all hosts.
severity − Severity level indicator, as described below:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
informational − Specifies that informational messages will be sent to
the remote host. This corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the
remote host. This corresponds to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages
that are generated by the Switch will be sent to the remote host.
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
69
Advertisement
Table of Contents
