D-Link xStackTM DGS-3300 User Manual page 279

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To add route redistribution settings:
create route redistribute dst rip src
Purpose
Syntax
Description
Parameters
Restrictions
Route Source
RIP
Static
Local
DGS-3324SRi:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DGS-3324SRi:4#
Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
create route redistribute dst rip src {all | internal | external |
type_1 | type_2 | inter+e1 | inter+e2}] {metric <value>}
This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local switch is also redistributed
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
all – Specifies both internal an external.
•
internal – Specifies the internal protocol of the source device.
•
external - Specifies the external protocol of the source device.
•
type_1 - Calculates the metric (for RIP to OSPF) by adding the
•
destination's interface cost to the metric entered in the Metric
field.
type_2 - Uses the metric entered in the Metric field without
•
change. This field applies only when the destination field is
OSPF.
inter+e1 – Specifies the internal protocol AND type 1 of the
•
external protocol.
inter+e2 – Specifies the internal protocol AND type 2 of the
•
external protocol.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a HOP Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Metric
0 to 16777214
0 to 16777214
0 to 16777214
276
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2