D-Link xStackTM DGS-3300 User Manual page 332

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
Host Address
---------------
10.48.73.21
10.48.74.122
Total Entries: 2
DGS-3324SRi:4#
create ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create an OSPF area aggregation:
DGS-3324SRi:4#create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DGS-3324SRi:4#
delete ospf aggregation
Purpose
Syntax
Description
Metric Area_ID
--------------- -----------
2 10.1.1.1
1 10.1.1.1
Used to configure OSPF area aggregation settings.
create ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enable | disable]}
This command is used to create an OSPF area aggregation.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the
OSPF Area.
lsdb_type summary − The type of address aggregation.
advertise [enable | disable] − Allows for the advertisement trigger to
be enabled or disabled.
Only administrator-level users can issue this command.
Used to delete an OSPF area aggregation configuration.
delete ospf aggregation <area_id> <network_address>
lsdb_type summary
This command is used to delete an OSPF area aggregation
configuration.
329