D-Link xStackTM DGS-3300 User Manual page 209

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show auth_diagnostics
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current authentication diagnostics for port 16:
DGS-3324SRi:4#show auth_client
Command: show auth_client
radiusAuthClient
----------------------------------------------------------------------------------------
radiusAuthClientInvalidServerAddresses
radiusAuthClientIdentifier
radiusAuthServerEntry
----------------------------------------------------------------------------------------
radiusAuthServerIndex
radiusAuthServerAddress
radiusAuthClientServerPortNumber
radiusAuthClientRoundTripTime
radiusAuthClientAccessRequests
radiusAuthClientAccessRetransmissions
radiusAuthClientAccessAccepts
radiusAuthClientAccessRejects
radiusAuthClientAccessChallenges
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators
radiusAuthClientPendingRequests
radiusAuthClientTimeouts
radiusAuthClientUnknownTypes
radiusAuthClientPacketsDropped
CTRL+C ESC q Quit SPACE n
Used to display the current authentication diagnostics.
show auth_diagnostics {ports [<portlist> | all]}
The show auth_diagnostics command is used to display the
current authentication diagnostics of the Switch on a per port basis.
ports <portlist> − Specifies a range of ports. The port list is specified
by listing the lowest switch number and the beginning port number
on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port
4 − in numerical order.
all – Specifies that all ports will be viewed.
None.
0
D-Link
0
: 1
: 0.0.0.0
0
0
0
0
0
0
0
0
0
0
0
0
Next Page Enter Next Entry
206
a All