Eaton Powerware 9140 User Manual page 8

INTRODUCTION
2
Eaton 9140 UPS (7.5–10 kVA) User's Guide
Providing outstanding performance and reliability, the Eaton 9140's
unique benefits include the following:
S
Online, double-conversion, high-frequency UPS design with pure sine
wave output and power-factor correction. The UPS filters and
regulates incoming AC power and provides consistent power to your
equipment without draining the battery.
S
For hardwired models, choice of operation mode between
single-phase input mode and three-phase input mode.
S
6U rack height with the highest power density for a 10000 VA UPS.
S
Advanced Battery Module (ABM
battery management to increase battery service life, optimize
recharge time, and provide a warning before the end of useful battery
life.
S
Extended runtime with up to four EBMs.
S
Start‐on‐battery capability for powering up the UPS even if utility
power is not available.
S
Easily replaceable electronics module and batteries that simplify
maintenance by allowing you to replace them safely without
powering down the critical load.
S
Emergency shutdown control through the remote emergency
power-off (REPO) port, or the option to configure the REPO port as a
remote on/off (ROO) function.
S
Two standard communication options with a USB port and two DB-9
serial ports (one DB-9 port is reserved for service use).
S
Optional X-Slot cards with enhanced communication capabilities for
increased power protection and control.
S
Firmware that is service upgradable through the X-Slot or DB-9 ports.
S
Advanced power management with the Software Suite CD for
graceful shutdowns and power monitoring.
S
Backed by worldwide agency approvals.
S 164201622 Rev 3 www.eaton.com/powerquality
) technology that uses advanced
®