Eaton Powerware 9140 User Manual page 47

17. If the optional seismic mounting brackets are installed, secure the
brackets on the UPS to the rack using four M6 machine screws as
shown in Figure 23.
Verify that the vent holes on the sides of the UPS are not covered
by the seismic mounting brackets.
Tighten the wing bolts on the seismic mounting brackets.
Vent Holes
Figure 23. Securing the Optional UPS Seismic Mounting Brackets
18. Replace the electronics module by sliding it carefully into the
cabinet. Verify that it seats against the rear of the cabinet.
Turn the module lock switch to the LOCK position.
Eaton 9140 UPS (7.5–10 kVA) User's Guide
S 164201622 Rev 3 www.eaton.com/powerquality
INSTALLATION
M6 Screws
41