Windows 2000 Print Server Configuration; Configuring The Protocols; Configuring Tcp/Ip And Ipp For Printing - Lanier Copier System Edition Operating Instructions Manual

1. Windows 2000 Print Server Configuration

Configuring the Protocols

Configuring TCP/IP and IPP for Printing

Follow these instructions to configure the Network Interface Board and Windows 2000 to use the
TCP/IP protocol and IPP.
Configuring the printer
Configure the printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)
• Assign an IP address and make other settings required for using the TCP/IP protocol.
Reference
For more information about how to make the above settings, see "Windows 2000 Configuration" in
Printer Client Reference 1 that comes with this printer.
If DHCP is used to assign IP addresses, see
Note
After setting the IP address, use the ping command to confirm that it has been set correctly.
A
Click [Start], point to [Programs], point to [Accessories] and then click [Command Prompt].
B
Type the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message appears.
Request timed out.
Operating Instructions
p.242 "When Using
Administrator Reference 2
DHCP".
12