Lanier Copier System Edition Operating Instructions Manual page 128

Messages
Staple unit is in use for another func-
tion. Please wait.
Toner Cartridge Setting Error
Toner Cartridges are not set properly:
Black, Yellow, Magenta, Cyan
Open the part as shown and replace
the cartridge(s).
Toner is almost empty.
Replace Toner Bottle.
Transfer Unit Setting Error
Transfer Unit is not set properly.
Open the part as shown and set the
unit.
Tray # has a problem. Select another
tray and press [Continue].
To cancel job, press [Reset].
Required:<xxx> <yyy>
Operating Instructions
Description
Staple unit is in use for another func-
tion.
The indicated toner cartridge(s) is/are
not set correctly, or is not set.
The printer is almost out of indicated
toner.
The transfer unit is not set correctly,
or is not set.
There is a problem with the input pa-
per tray #.
#: tray number
<xxx>: paper size
<yyy>: paper type
Maintenance Guide 2 Copier System Edition
Wait until the staple job will be com-
pleted.
Set the indicated toner cartridge(s)
correctly.
See "Replacing Consumables and
Maintenance Kit" in Maintenance
Guide 1.
Replace the indicated toner car-
tridge(s).
Set the Transfer Unit correctly.
See "Setting Up" in the Setup Guide.
Turn the main power switch off and
then on. If the message appears again,
contact your sales or service repre-
sentative.
Reference
Before turning the main pow-
er switch, see "Turning Off
the Main Power" in Adminis-
trator Reference 1.
Solution
57