Lanier Copier System Edition Operating Instructions Manual page 127

Messages
RPCS memory overflow.
RPCS syntax error.
SDRAM module could not be recog-
nized.
Call service.
Selected paper tray is in use for an-
other function. Please wait.
Shift tray has a problem. Call service
representative.
Staple has been cancelled.
Staple is almost empty.
Staple unit has a problem. Call serv-
ice representative.
Operating Instructions
Description
The printer memory is not initialized
because the CDC memory was not re-
served via the system call.
The printer identified a syntax error.
This error results from; data trans-
mogrification caused by the transmis-
sion path problem, data interruption,
data transmission from other drivers,
etc.
The printer identified an optional
SDRAM error.
The input paper tray selected by the
printer driver is being used for anoth-
er function.
Malfunction occurs when using the
Shift function
The staple feature has been cancelled. Verify that the paper orientation and
Staple is almost empty in the stapler. Replace staples.
There is a problem with the staple
unit.
Maintenance Guide 2 Copier System Edition
Replace the installed memory.
Be sure to use the correct driver.
Remove and re-install the optional
SDRAM.
If the message appears again, contact
your sales or service representative.
Wait until the job will be completed.
Contact your sales or service repre-
sentative.
layout is properly set, and make sure
whether your desired settings or fin-
isher is selected.
Contact your sales or service repre-
sentative.
Solution
56