Blower Motor - Henny Penny 680 KFC Service Manual

The blower motor circulates air into the burner area to create
the correct heat for the fryer. If the blower fails, a sensor will
shut the power control valve down.
1. Remove the electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug-
ging the unit, or by turning off the wall circuit breaker,
or electrical shock could result.
1. Remove both side panels.
2. Remove the nut from the ground wire and remove ground
wire.
3. Disconnect wires at junction box on right, back of fryer.
4. Remove conduit fitting from the blower bracket,
5. Loosen hose clamp and remove hose from blower.
6. Remove two (2) screws from the frame which secures the
bracket, and lift bracket and blower assembly from unit.
7. Remove the three (3) nuts from the back of the blower and
remove the blower from bracket.
8. Replace new blower in reverse order of procedures.