Henny Penny 680 KFC Service Manual page 106

Henny Penny
SMS PROGRAMMING
(Continued)
SMS SPECIAL PROGRAM
MODE
1005
13. After the filter value is set, press and release the Function
button. "EOC" and "EXIT" flashes on the left side
of the display and "COOL" shows on the right side of the
display. The end-of-cycle, (EOC), exit point can be set to
COOL, SETP, or FITR, by pressing any of the product
buttons (EOC). At the end of a cook cycle the controls
can be set to return to COOL, the setpoint temperature, or
to signal the operator to filter the shortening.
14. After the end-of-cycle point is set, press and release the
Function button. "HEAD" and "COUNT" flashes on
the left side of the display and a number shows on the
right side of the display. The number on the right is the
number of head of chicken to be cooked when that prod-
uct button is pressed. The number can be changed by
pressing the appropriate product button.
Another product can be programmed while in the pro-
gram mode by following these procedures:
Press and hold the SCAN button at any time while in the
Program mode and the display will scroll "SELECT
PRODUCT". Then press any of the product buttons,
(1-0), and now that product can be programmed.
15. To program second interval, press and release the
SCAN button while in the Time Mode of the first mode.
"INIT 2" and "TIME" will flash on the left side of the display.
Then follow the steps above, starting with step 4.
Review Usage
1. Press and hold the Function button for two seconds until
"REG PROGRAM" shows in the display. As soon as
"REG PROGRAM" shows in the display, press and
release the Function button 1 time until "REVIEW USE"
shows in the display.
2. "DAILY" shows in the display. Press any of the Product
buttons to view the usage of that product. Press and hold
the Function button to exit Special Program mode.
NOTE
Model 680
6-33