Henny Penny 680 KFC Service Manual page 109

Henny Penny
SMS SPECIAL PROGRAM
(Continued)
6-36
3. Press and release the Function button and "MELT", MODE
"CYCLE", and "100s" shows alternately in the display,
along with the period (pulse) length of 4000. This should
not be changed until the factory is consulted.
4. Press and release the Function button twice and "MELT",
"ON-", "TIME", and "100s", shows alternately in the
display, along with the length of time the heat is on. This
should be set at 1700, and should not be changed until the
factory is consulted.
5. Press and release the Function button three times and
"COOL", "SET-", and "POINT" shows alternately in the
display, along with the temperature at which the control
exits the melt cycle. This is set at 250º F (121º C), and
should not be changed until the factory is consulted.
6. Press and release the Function button four times and
"AUTO", and "IDLE" shows alternately in the display,
along with "OFF". This should not be changed until the
factory is consulted.
7. Press and release the Function button five times and
"AUTO", "IDLE", and "MMSS" shows alternately in the
display, along with "0:00". This should not be changed
until the factory is consulted.
8. The last 3 functions in the Heat Control mode are used by
the factory only, and should not be changed.
Model 680
1005