Henny Penny 680 KFC Service Manual page 74

To enter the program mode, a password keystroke sequence
is required. Note that when performing this sequence, the
buttons must be depressed within one second of each other,
If not, the control will not enter the program mode.
1. Depress the square under the far right digit of the display.
2. Depress the "Select Time" button.
3. Depress the square under the far left digit of the display.
4. Depress the "Exit Cool" button.
You are now in the program mode of the control.
To program a cook cycle, the following steps should be
followed.
1. Follow the keystroke sequence and enter the program
mode.
2. Select the product you desire to program by depressing
the cycle button next to the product.
3. TIME will be flashing in the function display.
4. Use the four change buttons beneath the display to change
the displayed values. Program the starting time first.
5. Depress the SELECT TIME button, which allows you to
enter the second interval for time.
6. Program your second interval time. Repeat until all six
interval times have been programmed.
7. Depress the SELECT FUNCTION button. TEMP will be
flashing in the function display.
8. Repeat steps 4,5, and 6 until all six interval temperatures
have been programmed.
9. Depress the SELECT FUNCTION button until
PRESSURE is flashing in the function display. Digital
display will read OFF and ON.
10. Follow steps 4; 5, and 6 until all six intervals have been
programmed for pressure.