Henny Penny 680 KFC Service Manual page 107

Henny Penny
SMS SPECIAL PROGRAM
MODE (Continued)
6-34
Reset Usage
1. Press and hold the Function button for two seconds
until "REG PROGRAM" shows in the display. As soon
as "REG PROGRAM" shows in the display, press and
release the Function button 2 times until "RESET USE"
shows in the display.
2. When "CODE" shows in the display, press 1-3-5.
"DAILY will show in the display, and press any of the
Product buttons to reset them to 0.
Factory Presets (F/C, Gas/Electric, Speaker Volume,
Speaker Frequency, Codes, Initialize System)
1. Press and hold the Function button for two seconds until
"REG PROGRAM" shows in the display. As soon as
"REG PROGRAM" shows in the display, press and
release the Function button 3 times until "FAC PRESET"
shows in the display.
2. When "CODE" shows on the display, enter 2957.
"DEG" and "MODE" flashes in the display. Press any of
the product buttons to toggle from ºF to ºC, vice versa.
3. Press and release the Function button and "TYPE"
and "FRYR" flashes in the display. Press any of the
product buttons to toggle from "GAS" to "ELEC", or vice
versa.
4. Press and release the Function button twice, and "SPKR"
and "VOL" flashes in the display. The volume can be
changed from 01 to 10, 10 being the loudest.
5. Press and release the Function button 3 times, and
"SPKR" and "FREQ" will flash in the display. The
frequency can be set from 100 to 2000.
6. Press and release the Function button 10 times, and
"INTITIALIZE SYSTEM" scrolls across the display.
Press and hold any of the Product buttons and the display
will count down from 5. Once the display counts down,
release the Product button, and the control will set factory
preset parameters into the controls.
Before attempting to change the other modes in the
Factory Preset mode, please call Technical Service
Department at Henny Penny. 1-800-417-8405.
NOTE
Model 680
1005