Printronix SL4M User Manual page 216

Chapter 6
Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
Displayed Message
DO NOT POWER OFF
ETHERNET
INITIALIZING
Please Wait
ETHERNET READY
ETHERNET
RESETTING
Please Wait
LOADING PROGRAM
INTO FLASH
Please Wait
POWER SAVER MODE
PRINTER RESETTING
Please Wait
RESTORING
BOOT CODE
SDRAM TEST 32MB
STATUS:
LOADING FIRMWARE
Please Wait
216
Table 16. Status Messages
Can User
Explanation
Correct?
N/A This is a standard
warning message that
displays while the
printer is downloading
software.
N/A Ethernet is initializing.
N/A Ethernet Interface has
finished initializing.
N/A Ethernet Interface is
being reset.
N/A Expanded Flash
Cartridge download
mode only.
N/A This is a status
message. The printer is
in low-energy idle state,
the higher voltages are
off, the front panel is
dimmed, and only
+5Vdc logic circuits are
active.
N/A Printer finished loading
the program into flash
memory and is
automatically resetting
itself.
Yes Normal download
initialization message.
N/A Status only not an error.
N/A Normal message when
the printer is powered
up while holding down
both the
the Down keys in
preparation to
download software to
the printer.
Solution
Do not power off the
printer until
downloading is
complete.
No action is required.
No action is required.
No action is required.
No action is required.
No action required.
Sending a print job or
pressing any control
panel key turns off
power saver mode.
No action is required.
No action required.
No action is required.
Complete the
downloading
software procedure.
(Menu) and