Load Media - Printronix SL4M User Manual

Load Media

1. To load media, refer to "Loading Roll Media" on page 25 and complete
2. Thread the media over the front of the media guide, around the media
NOTE: The alternate media path is for inside wound label.
Media
Media
Guide
Media Guide
Roller
Frame
Opening
3. Loosen the thumbscrew, pull it outward, position the wind direction lever
NOTE: Wind direction lever in lower position = clockwise rotation.
step 1 through step 10. Be sure to open the side cover.
guide roller, and through the frame opening toward the media take-up
core. See Figure 18.
Alternate Rewind Path
NOTE: The wind direction lever
(not shown) is located behind
the thumbscrew.
Figure 18. Media Rewind Path
in the desired location, and tighten the thumbscrew. See Figure 18.
Wind direction lever in upper position = counterclockwise rotation.
Thumbscrew
Rewinder Full
Sensor
Load Media
Alternate
Media Path
Media
Take-Up
Core
Sensor
Thumbscrew
249