Appendix B
Using the Standard Peel without Liner Rewinder
c. If the EMC is memory only verify that the cartridge is installed
Using the Standard Peel without Liner Rewinder
Configure The Printer Menu
1. Set Media Handling to Peel-Off in the MEDIA SETUP menu.
See "Configuring the Printer" on page 61 for more information.
2. Calibrate the printer (see "Running Auto Calibrate" on page 47).
NOTE: Calibration in Peel-Off mode is allowed only if Cal in Peel Mode is set
CAUTION
When the printer calibrates in peel-off mode, a series of labels will
quickly dispense. Be prepared to remove the peeled labels as they
automatically peel or the printer will jam.
240
iv. Press the Up key until Admin User displays.
v. Select Enable and press
vi. Press the Up key until EMC FSS displays.
↵
vii. Press
to enter the EMC FSS menu.
viii. Press the Down key until View EMC Files displays.
↵
ix. Press
to enter the View EMC Files menu.
x. Press the Down key to scroll through the list of files stored on the
EMC.
xi
Find the font file name on the list.
correctly by doing the following:
i
When ONLINE or OFFLINE displays on the printer's LCD,
press
to enter Menu mode.
ii
Press the Left key until
↵
iii
Press
to enter the
iv
Press the Down key until EMC FLASH Installed displays. The
amount of memory displays in megabytes. If this does not
appear, the EMC has not been properly installed. Start over at
step 1 on page 238.
to Enable. Cal in Peel Mode appears only if Admin User is set to
Enable in the PRINTER SETUP menu.
↵
to enable the option.
DIAGNOSTICS displays.
DIAGNOSTICS menu.