Copying With Pre-Programmed Settings - Oce 9800 User Manual

Copying with pre-programmed settings

The Océ 9800 is equipped with a memory function which can be used to
retrieve the settings of 5 different copying jobs. This is useful for jobs which
have to be done on a regular basis. Your key operator can store settings in 5
different programs. Note that each program represents all direct settings of the
operating panel. You only need to retrieve the program and press the start
button, thus saving valuable programming time.
The default settings are used for copy and print jobs.
Note:
Retrieving a program
Press the section button 'Program'.
1
Select 'Load' using the higher/lower buttons (see figure 58).
2
Copies:
Ready to copy
0
stamp
Normal fold
Exposure
copy delivery belt
Synchro cut Zoom: % (auto)
Zoom % (auto)
Roll: (auto)
Roll: (auto) Sort by set
Sort by page Copies: 10
............................................................................................................................................................
Copies: 1
Default
settings
[58] Retrieving a program
Press the function buttons 1 through 5 to load the required program (see
3
figure 58).
The operating panel will now show the settings for the selected copy job.
4
Feed the original.
5
Programs allow you to call-up predefined settings. You may change
Note:
individual settings with the appropriate buttons. These modified settings
will only be used for the copy jobs, and will not affect the program.
68 Océ 9800 Copier/Printer User Manual
photo
shift
standard cut
copy delivery:belt
Zoom: %(auto))
Roll: (auto)
Sort by page
Copies: 2
2
1 1
................
................ ................
Machine
Program
Program
Load
mirror
copydeliver:belt
fold:
Zoom: % (auto)
Zoom: % (auto)
Roll:3
Roll:4
Sort by set
Sort by page
Copies: 3
Copies: 5
Margin
3
3
(mm)
................ ................
Finishing Copy
4
5