Loading Rolls Of Copy Material - Oce 9800 User Manual

Loading rolls of copy material

The Océ 9800 has four rolls, each of which may be loaded with copy material
of a different size or type. The operating panel displays width and type of
media on each roll.
Attention:
which type of copy material was loaded. That is, paper, transparent or
polyester. The roll width will be detected automatically.
The definition of the new copy material is important when 'Automatic roll
change' has been switched on (see 'Defining automatic roll change' on
page 103), and to prevent fold errors.
Caution:
in position two in the upper paper compartment or position four in the
lower paper compartment. Such roll must have a diameter smaller than 184
mm.
Re-loading paper
Open the appropriate paper roll compartment (see figure 126).
1
[126] Opening the appropriate paper roll compartment
If necessary empty the chip tray (see 'Emptying the chip tray' on page 138).
2
Remove the roll holder from the paper roll compartment.
3
Maintenance
After loading new copy material, you need to inform the system
Place heavy rolls (A1, A0 and 200 meter rolls of paper) preferably
135