Oce 9800 User Manual page 99

The new defaults are now stored in memory. Note that not all active settings
can be displayed. The maximum number to be displayed is eight.
When ready, quit the key operator mode.
5
You have the possibility to re-store the factory default settings in your 'default
settings' program by erasing the default settings program.
Returning to the factory default settings
Press the section button 'Program'.
1
Select 'Erase' using the higher/lower buttons.
2
Press the function button 'Default settings'.
3
You will be asked to confirm the erase procedure.
Quit the key operator mode.
4
Storing settings under a program button
Make the settings you want to program.
1
Press the section button 'Program'.
2
Select 'Store' using the higher/lower buttons (see figure 91).
3
Copies:
Ready to copy
0
Normal
Exposure
copydelivery:belt1
Synchro cut
Zoom: % (auto)
Zoom % (auto)
Roll: (auto)
Roll: (auto)
Sort by set
Sort by page
Copies: 3
............................................................................................................................................................
Copies: 1
Default
settings
[91] Storing a copy job
Select the appropriate button to store the copy job into memory. The copy job
4
is now stored in memory.
You will be asked to confirm the store procedure when the program
Note:
already contains data.
When ready, quit the key operator mode.
5
Key operator
1 2
................
................ ................
Machine
Program
Program
Store
Margin
3
(mm)
................ ................
Finishing Copy
4
5
99