If you leave the scanner unattended for a while after the last copy
(approximately 25 seconds), it will return to its default settings and display:
Copies:
Ready to copy
0
[32] 'Ready to copy', the machine is ready to accept a new original and the engine is not printing
The 'Ready to copy' message invites you to define new settings and feed a new
original into the scanner. Note that the scanning of this 'new' original has to be
started by pressing the start button.
If you are copying thick originals or originals in a carrier sheet, it is
Note:
recommended to use the output at the rear side of the scanner to ensure correct
delivery (see 'Original Delivery Tray (optional)' on page 47).
Making copies
Enter the number of copies using the numeric buttons.
1
Make other settings as required.
2
Insert the original face up left aligned, along the original guide on the scanner
3
feed table (see figure 33).
[33] Inserting the original
Press the start button.
4
The copying process will start. If 'Automatic feed' is displayed in the system
status area, the next original will be fed automatically without pressing Start.
Basic copy jobs
................
................
Machine
Program
...............
................
Finishing
Copy
43