Oce 9800 User Manual page 61

Selecting reinforcement
Open the 'Fold' card in the 'Finishing' section.
1
Press the function button 'Binding edge' until 'Reinforce' is selected (see
2
figure 53).
.
Copies:
Ready to copy
0
Stamp
Fold
delivery
......................................................................................................................................
Fold
Folding
method
[53] Selecting Reinforcement
Make other settings as required.
3
Feed the original.
4
Reinforcing is only possible with the Standard folding method. When you
Note:
select reinforcing with another folder setting method the following message
will appear on the display: 'Reinforcing only possible with Standard folding
method'. As soon as you make another selection this message disappears.
When feeding reinforced originals into the scanner you have to fold
Note:
down the reinforcement strip so that it no longer sticks out of the page.
For more information about inserting a new tape roll and other
Note:
maintenance issues, see 'Maintenance of the Reinforcement Unit' on
page 143.
When reinforcing is disabled by some mechanical failure you can still
Note:
make copies or prints. When you select reinforcing the following message is
displayed: 'Reinforcing not possible'. After a few seconds this message
disappears and reinforcing is deselected (see 'Clearing a paper jam in the
folder' on page 167).
Basic copy jobs
Portrait
first fold
Standard
1 + 2 fold
Folding Folding
method length
................ ................
Machine Program
310 mm
190 mm
297 mm
210 mm
Folding Folding
length width
................
................
Copy
Finishing
Reinforce
Punch
20 mm
Binding
edge
61