To Connect The Sc Serial Management Port; Figure 2-16 Ethernet Network Connections; Figure 2-17 System Controller Serial Connection - Fujitsu Sparc Enterprise T2000 Installation Manual

Ethernet Network Connections
FIGURE 2-16
1. Connect a Category 5 cable from your network switch or hub to Ethernet Port 0
(NET0) on the rear of the chassis.
2. As needed, connect Category 5 cables from your network switch or hub to the
remaining Ethernet ports (NET1, NET2, NET3).
▼

To Connect the SC Serial Management Port

The SC serial management port is marked SER MGT. It is the leftmost RJ-45 port on
the rear of the chassis (
System Controller Serial Connection
FIGURE 2-17
NET0
NET1
).
FIGURE 2-17
SER MGT
NET2
NET3
Chapter 2 Installing the Server 27