Default System Console Connection Through The Serial Management And Network Management Ports; Figure 1-1 Directing The System Console - Fujitsu SPARC Enterprise T2000 Administration Manual

You must also ensure that the system console is directed to the appropriate port on
the SPARC Enterprise T2000 server's back panel—generally, the one to which your
hardware console device is attached (see
input-device and output-device OpenBoot configuration variables.
System
console
Directing the System Console
FIGURE 1-1
Default System Console Connection Through the Serial
Management and Network Management Ports
On your server, the system console comes preconfigured to allow input and output
only by means of the system controller. The system controller must be accessed
either through the serial management port (SER MGT) or the network management
port (NET MGT). By default, the network management port is configured to retrieve
network configuration using DHCP and to allow connections using SSH. You can
modify the network management port configuration after connecting to ALOM CMT
through either the serial or network management ports.
4 SPARC Enterprise T2000 Server Administration Guide • April 2007
Server
OpenBoot configuration
variable settings
input-device=virtual-console
output-device=virtual-console
input-device=keyboard
output-device=screen
). You do this by setting the
FIGURE 1-1
Ports Console devices
Serial
management
Network
management
Graphics
card
TIP line
Alphanumeric
terminal
Terminal
server
Network
device
Graphics
monitor