Bezel; Removing The Front Bezel; Installing The Front Bezel - HP Z200 Maintenance And Service Manual

Bezel

This section describes how to remove and install the front chassis bezel.

Removing the front bezel

To remove the front bezel:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. If the security screw is installed (next to the middle front bezel release tab), remove the screw. (See
Front bezel security on page
4. Lift the release tabs (1), and then rotate the front bezel off the chassis (2).
Figure 5-5

Installing the front bezel

To install the front bezel:, align the tabs discussed in the previous section and rotate the bezel until it
snaps in place.
1. Align the tabs discussed in the previous section and rotate the bezel until it snaps in place.
2.
If you are using the bezel security screw, replace the screw next to the middle front bezel release
tab.
74 Chapter 5 Replacing components
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
75.)
Removing the front bezel
Predisassembly procedures on page
72).
69.
ENWW