Removing And Replacing The Primary Hard Drive - HP Z200 Maintenance And Service Manual

CAUTION:
down. Other procedures may result in system hangs, data loss, or even drive damage. The
component supplier's user guide describes a procedure for inserting or removing the carrier (with
drive) while the workstation is booted and then powering the drive via the power switch on the
enclosure. However, Microsoft Windows XP and Windows Vista do not support this action.
a. Insert the key (1) and turn it clockwise (2).
Figure 5-44
b. Press the handle to open the door (3).
c. Insert the drive carrier.
d.
Lock the carrier by inserting the key and turning it counterclockwise (3).
CAUTION:
might result in damage to your removable hard drive system.
12. Replace the access panel (see
13. Restore all connections and equipment that you removed during the
on page

Removing and replacing the primary hard drive

The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the
hard drive:
1. Follow the procedures listed in the
CAUTION:
data loss.
2. Remove the access panel (see
3.
Remove the front bezel (see
ENWW
Insert or remove the carrier (with a disk drive) only when the workstation is shut
Locking the carrier
Always lock the drive before shipping or moving the computer. Failure to do so
Installing the access panel on page
69.
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page
Predisassembly for drives on page 79
Removing and installing components
72).
Predisassembly procedures
section.
72).
74).
101