Accessing The Computer Setup (F10) Utility - HP Z200 Maintenance And Service Manual

Accessing the Computer Setup (F10) Utility

To access the Computer Setup (F10) Utility menu:
1. Power on or restart the computer.
2. When the display is active and F10=Setup appears in the lower right corner of the screen, press
F10.
If you do not press
press F10
starting if you miss the opportunity to press F10.
3. Select the language from the list and press the
In the Computer Setup (F10) Utility menu, five headings are displayed: File, Storage, Security,
Power, and Advanced.
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow
keys to select an option, and then press Enter.
5. Choose from the following:
To apply and save changes, select File>Save Changes, and then select F10=YES.
●
To remove changes you have made, select Ignore Changes and then select F10=YES.
●
To reset to factory settings, select File>Default Setup>Restore Factory Settings as
●
Default. Press
restores the original factory system defaults.
CAUTION:
changes, because the Complementary Metal-Oxide Semiconductor (CMOS) could become corrupted.
After you exit the F10 Setup screen, you can disconnect power from the computer.
ENWW
F10 at the appropriate time, try again. Turn the computer off, then on, and
again to access the utility. You can also press the
to accept the changes, and then select Apply Defaults and Exit. This
F10
Do not power off the computer while the ROM is saving the Computer Setup (F10) Utility
Ctrl + Alt + Delete
Enter key.
The Computer Setup (F10) Utility
keys before
29