Remove Bezel Blanks; Locate System Board Drive Connections; Remove The Front Bezel (See Removing The Access Panel - HP Z200 Maintenance And Service Manual

Remove bezel blanks

On some models, you may need to remove the bezel blanks that cover the 3.5-inch and 5.25-inch drive
bays before you install a drive. To remove a bezel blank:
1. Remove the access panel (see
2. Remove the front bezel (see
3. On the inside of the bezel, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1) and then slide the bezel blank back and to the left to remove
it (2).

Locate system board drive connections

Adding a new drive may require that you make new connections from the drive to the system board.
Refer to the following illustration and table to identify the system board drive connectors.
Figure 5-10
80 Chapter 5 Replacing components
Removing the access panel on page
Removing the access panel on page
System board drive connections
72).
72).
ENWW