HP Z200 Maintenance And Service Manual page 139

Small form factor workstation
Hide thumbs Also See for Z200:
Table of Contents

Advertisement

4.
Push down on the expansion card retention clamp levers on the inside of the chassis to open the
retention clamp (1) as shown below.
Figure 5-72
5.
If the card slot has a latch, release the latch (1), and then carefully lift the card from the chassis
(2).
Figure 5-73
6.
Install an expansion slot cover if you do not intend to replace the card.
7.
Close the expansion card retention clamp. If the expansion card retention clamp does not close,
ensure that all cards are properly seated, and then try again.
8.
Replace the access panel (see
9.
Restore all connections and equipment that you removed during the
on page
ENWW
Releasing the retention clamp
Removing the expansion card
Installing the access panel on page
69.
72).
Predisassembly procedures
Removing and installing components
127

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents