Download  Print this page

HP Z200 Maintenance And Service Manual Page 181

Small form factor workstation.
Hide thumbs

Advertisement

Table 6-9
POST error messages (continued)
Screen message
213—Incompatible Memory
Modules
214—DIMM Configuration
Warning
215—DIMM Configuration
Error
216—Memory Size Exceeds
Maximum Supported
301—Keyboard Error
303—Keyboard Controller
Error
304—Keyboard or System
Unit Error
510—Splash Screen image
corrupted
511—CPU Fan not detected
512—Chassis fan not
detected
ENWW
Probable cause
A memory module in the memory
socket identified in the error message
is missing critical SPD information, or
is incompatible with the chipset.
DIMMs are not installed correctly (not
paired correctly).
The amount of memory installed
exceeds that supported by the
hardware.
Keyboard failure.
I/O board keyboard controller is
defective or is not set properly.
Keyboard failure.
Splash Screen image has errors.
Fan is not connected or is defective.
Fan missing, disconnected, or
defective.
Recommended action
1.
Verify the memory module type.
2.
Insert the DIMM in another memory socket.
3.
Replace the module with a DIMM conforming
to the SPD standard.
See the service label on the computer access panel for
the correct memory configurations, and reseat the
DIMMs accordingly.
1.
Verify how much memory the computer supports.
2.
Remove the excess memory.
1.
Reconnect the keyboard with the computer
powered off.
2.
Check the connector for bent or missing pins.
3.
Be sure that none of the keys are pressed.
4.
Replace the keyboard.
1.
Reconnect the keyboard with the computer
powered off.
2.
Connect a keyboard directly to the computer
(instead of through a switch box).
3.
Replace the system board.
1.
Reconnect the keyboard with the computer
powered off.
2.
Connect a keyboard directly to the computer
(instead of through a switch box).
3.
Be sure that none of the keys are pressed.
4.
Replace keyboard.
5.
Replace system board.
Update system BIOS.
1.
Reseat the fan cable.
2.
Reseat the fan.
3.
Replace the fan.
1.
Reseat the fan cable.
2.
Reseat the fan.
3.
Replace the fan.
Diagnostic codes and errors
169

Advertisement

Table of Contents

   Related Manuals for HP Z200

This manual is also suitable for:

Z200

Comments to this Manuals

Symbols: 0
Latest comments: