Download  Print this page

Installing A Dx115 Dataport Hard Drive - HP Z200 Maintenance And Service Manual

Small form factor workstation.
Hide thumbs

Advertisement

c.
Remove the drive by sliding it toward the front of the carrier until it disengages from the
carrier adapter and then lifting the drive out of the carrier.
Figure 5-32
d.
To replace the hard drive, see
10.
Replace the access panel (see
11.
Restore all connections and equipment that you removed during the
on page

Installing a DX115 Dataport hard drive

The optical disk drive bay can also accommodate a DX115 Dataport removable hard drive.
NOTE:
The CRU Dataport DX115 does not fit in all optical drive bays. It is longer than most optical
drives. Choose the optical bay for the CRU Dataport DX115 which best fits your computer
configuration.
To install a DX115 unit:
1.
Follow the procedures listed in the
CAUTION:
data loss.
NOTE:
not need to remove the front bezel to install the DX115 unit.
2.
If you are replacing an existing optical disk drive, remove it. See
on page
ENWW
Removing the drive
Installing the access panel on page
69.
Failure to follow the predisassembly procedures can result in equipment damage or
For better clarity, the figures in this section do not show the front bezel. However, you do
83.
Installing a DX115 Dataport hard drive on page
Predisassembly for drives on page 79
Removing and installing components
95.
72).
Predisassembly procedures
section.
Removing an optical drive
95

Advertisement

Table of Contents

   Related Manuals for HP Z200

This manual is also suitable for:

Z200

Comments to this Manuals

Symbols: 0
Latest comments: