Removing A Dx115 Dataport Hard Drive; Replace The Front Bezel - HP Z200 Maintenance And Service Manual

5. Place the drive's guide screws into the J-slots in the drive bay. Then slide the drive toward the front
of the computer until it locks into place.
TIP:
Figure 5-23
6.
Connect the drive cables:
a. If installing a second hard drive, connect the power and data cables to the rear of the drive
and connect the other end of the data cable to the next available (unpopulated) SATA
connector on the system board by following the numbered sequence of the connectors.
b.
If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled MEDIA. If the media card reader includes a
1394 port, connect the 1394 cable to the 1394 PCI card.
NOTE:
system board drive connectors.
7. Replace the optical drive. (See
8.
Replace the front bezel (see
9. Replace the access panel (see
10.
Restore all connections and equipment that you removed during the
on page

Removing a DX115 Dataport hard drive

To remove a DX115 Dataport hard drive:
1. If a drive case is installed in the carrier, remove it:
90 Chapter 5 Replacing components
Angle the drive toward one side of the chassis to line up the guide screws with the slots.
Installing a drive into the drive cage (media card reader shown)
See Locate system board drive connections on page 80
Installing the front bezel on page
69.
Installing an optical drive on page
Installing the access panel on page
for an illustration of the
85.)
74).
72).
Predisassembly procedures
ENWW