Removing And Replacing A Primary 3.5-Inch Hard Drive - HP ProDesk 600 G2 Small Form Factor Maintenance And Service Manual

Removing and replacing a primary 3.5-inch hard drive

CAUTION:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the drive cage to its upright position
4. Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
5. Pull the release lever next to the rear of the hard drive outward (1). While pulling the release lever out,
slide the drive back until it stops, and then lift the drive up and out of the bay (2).
38 Chapter 4 Removal and replacement procedures: Small Form Factor
All removable media should be taken out of a drive before removing the drive from the computer.
(Access panel on page
(Preparation for disassembly on page
20).
(Rotating the drive cage on page
19).
32).