Connecting Cables To The Rmx 2000 - Polycom RMX 1500 Getting Started Manual
Multipoint control unit
Hide thumbs
Also See for RMX 1500:
- Administrator's manual (1118 pages) ,
- Getting started manual (160 pages) ,
- Hardware manual (34 pages)
Table of Contents
Advertisement
Chapter 2-First Time Installation and Configuration
2-16
•
Using a shelf
— Install the shelf, supplied by the rack manufacturer, in the rack.
— Mount the RMX on the shelf.
— Fasten the RMX to the rack with screws through the four holes in
the RMX's front mounting brackets.
Connecting Cables to the RMX 2000
Do not remove the protective caps from LAN1, LAN3 and ShMG ports.
Connect the following cables to the back panel:
•
Power cable
•
On the RTM IP card connect the LAN cable to LAN 2 Port
•
On the RTM ISDN card connect the E1/T1 Cables to PRI Ports
LAN 2 Connection
E1/T1 Connection
Power
Off/On
switch
Cable
Advertisement
Table of Contents
Need help?
Do you have a question about the RMX 1500 and is the answer not in the manual?
Questions and answers