Procedure 2: Product Registration; Obtaining The Activation Key - Polycom RMX 1500 Getting Started Manual

Chapter 2-First Time Installation and Configuration

Procedure 2: Product Registration

2-22
2
Power the RMX On.
AC System - Turn ON the power by pressing on the power switch
located on the rear panel of the RMX 1500/2000/4000.
DC System (RMX 4000) - Turn ON the Main that supplies power to
the RMX and then turn ON each of the DC power rail modules.
The parameters in the lan.cfg file are uploaded from the USB key to
the RMX's memory and applied during the power-up sequence.
System power-up sequence may take up to five minutes.
During the First-time Power-up the red ERR LED on the RMX's front
panel remains ON until both the Management and IP Network Services
have been defined.
When the RMX configuration is completed (including the
Management and IP Network Services), and if there are no System
Errors, the green RDY LED on the CNTL module (on the RMX's front
panel) turns ON.
3
Remove the USB key once the connection to the RMX is established
and the Login screen is displayed. For more details, see "Procedure 3:
Connection to MCU" on page 2-23.
Before the RMX can be used, it is necessary to register the product and
obtain an Activation Key.
During first-time power-up, the Product Activation dialog box is displayed,
requesting you to enter an Activation Key.

Obtaining the Activation Key

1 Access the Service & Support page of the Polycom website at:
http://support.polycom.com
2
Login with your Email Address and Password or register as a new user.
3
Select Product Registration.
4 Follow the on-screen instructions for Product Registration and Product
Activation. (The RMX's serial number is on a sticker on the back of the
unit). For more information, refer to the RMX Software Licence
document you received with your shipment.